Brushless water pump 800 L/H

Durable and waterproof.
The shell is made of plastic, corrosion-resistant, impact-resistant, durable, acid and alkali resistant. The stator and circuit board of the motor are potted with epoxy resin, which is completely isolated from the rotor, so it solves the problem of water leakage caused by the long-term diving of the water pump, and the pump is completely waterproof. The shaft core is made of stainless steel. The maximum flow rate can reach 3.5GPM (800L/H), and the maximum water outlet is up to 5 meters/16.4ft.
 
Quiet design.
The maximum volume of the circulation pump is 40db.
 
Long service life.
The pump is with 12V-voltage and a 1.27 cm external thread. The outer diameter of the brass coupler is 10 mm. With a 5521 DC female plug, 1.5 meters data cable, and long service life: 20,000 hours.
 
Power saving.
It can save more than 50% of electricity than ordinary water pumps, a low-voltage power supply, which gives great safety assurance. Pure copper motor, no carbon brush, no pollution, electronic commutation, low heat generation, high efficiency. The pump can be used up to 100°C, need to be recycled, and cannot be used in diving.
 
Specifications
Material: Plastic
Purpose: Submersible pump
Structural Principle: Centrifugal pump
Drive Mode: Electromagnetic
Delivery Medium: Clean water pump
Impeller Structure: Semi-open impeller
Impeller Suction Method: Single suction
Number Of Impellers: 6
Voltage: 12V
Power: 15W
Maximum Lift Head: 5M (16.4ft)
Maximum Flow: 800 L/H (211GPH)
Water Inlet Diameter: 20 mm / 0.79″ with 1/2 threaded interface
Outlet Diameter: 20 mm / 0.79″ with 1/2 threaded interface
Cord Length: about 150 cm / 59″
Adapter: AC/DC Adapter
Input: AC 100 – 240V
Output: DC 12V – 2000mA
Package Weight: about 220 gr
Suitable for: Fish, Aquariums (small fish tanks, waterscape decorations, hydroponic circulation pumps, pet drinking fountains, humidifiers, miniature fountains, solar water heaters, water circulation pumps, etc.)
 
 
Instructions for use
Put the pump horizontally and install a suction cup on the bottom of the pump to help reduce noise and vibration. And the inlet needs to be fitted with a filter cover for diving.
If there is less water in the pump or no water, there may be air inside the pump impeller or in the water low pipe. Switch on-off the power repeatedly for several times to eliminate the air in the pump impel and the pipe. If necessary, manually remove the air in the pipe, and it can be restored to normal working condition when the pump discharges water.
 
 
Notes
Do not connect the power cord +,- pole reversely, otherwise it will damage the pump.
Do not use non-standard power. If the voltage is too high, it will damage the pump, and if the voltage is too low, it can cause the pump’s performance to drop or not work.
Do not let the pump work in a state of water shortage, because idling and drying will damage the pump.
Do not put the pump in sediment-laden water as well as vicious and acid-base liquids to use.
Do not place the pump in an environment above the temperature indicated on the pump
When the pump is used in a high-temperature environment (60-100 ℃/ 140-212°F), installation only with circulating water.


Packing List
One DC water pump
Two copper adapter
Two tighten the hose clamp
Two sealing gasket
One fixed base
 
 
Notes
The real product colors may be slightly different from what you see in the images.
The product dimensions may be slightly different from what is written in the product specifications.